How Storage Heaters Work. How storage heaters work is very straight forward. Electricity to the units is restricted to off peak hours. When 'on', electricity heats the elements, which in turn heat the bricks. Creda night storage heater 79141 manual instruction Heaters. Creda 79164C TSR24M (1991 - 1997) Slimline Manual Storage Heater 3.4kW Spares. The specification number of your Creda storage heater will be located on a data plate. From Creda Heating. 3.4kW heater shelf pack 79062, 2.5kW heater shelf pack 79052 and 1.7kW heater shelf pack 79042 TSR Electric Storage Heaters Owners Guide Automatic Manual Model Nos: 79341S 79351S 79361S 79344/6S 79354/6S 79364/6S Cat. Nos: TSR12AW TSR18AW TSR24AW TSR12MW TSR18MW TSR24MW • The Installation must be carried out by trained personnel. • A means for disconnection must be.
• TSR Electric Storage Heaters Assembly Instruction Automatic Manual Model Nos: 79341S 79351S 79361S 79344/6S 79354/6S 79364/6S Cat. Nos: TSR12AW TSR18AW TSR24AW TSR12MW TSR18MW TSR24MW This product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3.
![Electric Thermal Storage Heaters Prices Electric Thermal Storage Heaters Prices](http://www.gbase.de/uploads/ci/shots/Herr-der-Ringe---Schlacht-um-Mittelerde_b_10079.jpg)
• IMPORTANT NOTES: It is important to read these instructions carefully and also note the information given on the heater itself. As these particular instructions refer to the assembly and installation of a new heater, they should be retained by the installer; not left behind for the user as this would invite the dismantling and servicing by unqualified persons.
![Creda Storage Heater 79164c Manual Treadmill Creda Storage Heater 79164c Manual Treadmill](https://ipcmobile.com/wp-content/uploads/2008/07/512x512bb10.jpg)
• PLEASE DON’T TAKE CHANCES Site conditions may vary considerably and Creda cannot recommend the correct wall fixings to be used. It is the responsibility of the installer to ensure that adequate permanent fixing has been achieved. Purely for guidance the suggested fixings are made for certain wall materials but this list is not comprehensive or authoritative. • First, turn carton upside down Open bottom flaps on carton Packing corner fitments contain heater feet It is preferable to fit the heater feet whilst the heater is still in its carton. Turn the carton upside down and open the bottom flaps.
The corner fitments contain both feet and the fixing kit. • WALL FIXINGS - VERY IMPORTANT When bracket is securely fixed, replace You must fit a the heater under the bracket angle retaining screw at and align screw holes on heaters each end of the ends. There are two fixing slots at each end of heater. • MAINS TERMINALS IMPORTANT: for earthing, loosen the earth screw sufficiently to wrap the mains’ earth wire around it between flat washer and cup washer, and retighten the earthing screw.
Feed the mains cable through the cable clamp and make ENSURE THAT CABLE CLAMP connections as marked on the heater. • Temporarily remove one central element to provide access for the rear rank of bricks. Loosen terminals on one of the elements and remove this to allow installation of rear rank of storage bricks.